![]() What speed would you suggest Scott I wasn’t going to buy this laser cutter until someone comment that they use it all the time for cardstock and it doesn’t char Now I am just totally confused I must admit though I was excited even just to get it to cut a rectangle out at this stage I am just trying to find the best settings The Laser “shines” on plywood, MDF and Acrylic, but paper materials do char. I use a Silhouette for my cardstock work. Speed control is thru the pop up panel when you go to cut, and 700mm/sec is very fast, if you’re actually going that fast, you may have trouble with rounded corners or dropped steps, causing distorted cuts. An air assist attachment will help, as will cutting faster and raising the power as required.Ĭorel does not have control over the laser power in the k40, just ignore the setting and use the knob (also true in LaserDRW) Hi Brand new user of the K40 Laser cutter Can someone help with the settings for cutting cardstock for handmade cards I am cutting at 700mm with the current regulation dial down very low only registering 3 or 4 on the mA meter but still charing quite a bit when I go to cut settings in coralLaser it says my power is 75% but it is light grey so I am unable to adjust the power down can anyone please helpĬO2 lasers don’t cut card stock as well as bladed CNC cutters, I don’t know of anyone who has been able to get a cut without at least a little charring.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |